General Information
17
Pretest Procedures
Step Procedure
I 1. VehicleIgnition:Key-ON,Engine-OFF.
2. Measure for ignition voltage on pins 10 and 9 of the harness connector.
a. If the voltage is within 0.6 volts of the battery voltage measured in Step A.
i. Proceed to Step J.
b. If the voltage is less than 0.6 volts of the battery voltage measured in Step A or open.
i. TestFailed.Checkcomponentfuse.TroubleshootpowersupplytotheFLRforopen/corroded
connections or shorts to ground and repeat Step.
Pin #Description
10
9
Comments to this Manuals